Home Distribution Amplifiers SRS FS735 Double Width 19 Rack Distribution Amplifier

SRS FS735 Double Width 19 Rack Distribution Amplifier

Product Code:
21626
Manufacturer: Stanford Research Systems
  • Sine wave outputs (+13 dbm)
  • Amplitude leveling
  • Low additive phase noise
  • High channel-to-channel isolation
  • High return loss

More info and finance questions

Request a Quote

Lambda Exclusive Promotion:
Additional 12 months warranty for free (2 years total) via our UK Service Centre.

The Stanford Research Systems FS730/FS735 Series Distribution Amplifiers are used to distribute a low noise 10 MHz frequency reference. Each system has one input and seven outputs, all on BNC connectors. The input is coupled through a series LC network allowing the use of inputs with a dc offset. The input source impedance is 50 Ω at 10 MHz.

The SRS FS730/FS735 Series Distribution Amplifiers are used to distribute a low noise 10 MHz frequency reference. Each system has one input and seven outputs, all on BNC connectors. The input is coupled through a series LC network allowing the use of inputs with a dc offset. The input source impedance is 50 Ω at 10 MHz.

The input is conditioned by a limiter which provides several advantages. It removes amplitude modulation from the input signal, outputs have fixed amplitude, and input noise that occurs more than 50 mV away from the zero-crossing is blocked. Virtually any waveform with a duty cycle near 50% may be used as an input.

The input limiter is followed by a bandpass filter and a fixed gain amplifier. This signal is passed to the seven output amplifiers, each of which is followed by a low pass filter and an output transformer. All of the outputs have 50 Ω source impedance and provide a 1Vrms (+13 dBm) sine wave into a 50 Ω load.

There are four indicator LEDs. The “power” LED indicates that the unit has AC power. The “signal” LED indicates that an input signal is present. The “overload” LED indicates that the input signal has excessive amplitude. The “fault” LED indicates one or more of these conditions: no input signal, excessive input signal, no output signal, or low internal DC power supply.

Configuration

The FS73x series of products can be configured as half-width, 1U, benchtop instruments (FS730, or in full-width, 1U, 19" rack-mount enclosures (FS735).

The FS730/1 model provides 7 output BNC connectors on the front panel, and can be rack mounted with an optional rack mount kit.
The FS735/1/1 model provides 14 output BNC connectors on the rear panel, with status indicators on the front panel. Several types of distribution amplifiers are available as listed below. Different types may be combined within the FS735 chassis.

Input
Frequency 10 MHz, ±1 %
Level 0 dBm to +16 dBm  (0.6 Vpp to 4 Vpp)
Waveform Any with ≈ 50 % duty   
Impedance 50 Ω, ±5 % at 10 MHz
Coupling Series LC (Open at DC)
Output
Waveform Sine
THD  
Level (50 Ω load) +13 ±1 dBm (1 Vrms, 2.82 Vpp)
Level (high-Z load) 2 Vrms (5.6 Vpp)
Impedance       50 Ω, ±5 % at 10 MHz
Coupling Transformer. (Short at DC)
Bandwidth ±200 kHz (-3 dB)
Spurious  
Isolation >100 dB (1)
Pulling  (1,2)
TC of phase ≈ -5 ps/°C
Additive phase noise (with +7 dBm input)
Offset (Hz)        Noise (dBc/Hz)
1 -125
10 -135
100 -146
1k -155
10k -158
100k -158
General
Power 10 W, 100/120/220/240 VAC, 50/60 Hz
Dimensions
         FS730
         FS735

8.3" × 1.5" × 8.0" (WHL)
17" × 1.5" × 8.0" (WHL)
Warranty One year parts and labor on defects in materials and workmanship

(1) Measured with 1 Vrms at 10.001 MHz from a 50 Ω source applied to an adjacent output. The isolation increases at frequencies far away from 10 MHz.

(2) The pulling is comparable to that caused by a reflected wave from an unterminated cable on an adjacent output.

Write Your Own Review
You're reviewing:SRS FS735 Double Width 19 Rack Distribution Amplifier
Your Rating
PhotoProduct SKU
SRS FS730/3 CMOS Logic Distribution AmplifierSRS FS730/3 CMOS Logic Distribution Amplifier- >
SRS FS730/2 5 MHz Distribution AmplifierSRS FS730/2 5 MHz Distribution Amplifier- >
SRS FS730/1 10 MHz Distribution AmplifierSRS FS730/1 10 MHz Distribution Amplifier- >
SRS FS730/4 Broadband 50Ω Distribution AmplifierSRS FS730/4 Broadband 50Ω Distribution Amplifier- >
SRS FS730/5 Broadband 75Ω Distribution AmplifierSRS FS730/5 Broadband 75Ω Distribution Amplifier- >