Model 711A Optical Isolator
- 500-645nm tuning range
- 37-40dB isolation
- 92% transmission
Configuration:
- Optical Isolator with input and output polarisers pre-aligned to the rotator glass.
- In this configuration the “input end” is the end with the tuning ring.
- The input polariser is aligned for vertical input polarisation and the output polarizer is 45 degrees to the input.
- If your source is horizontally polarized, simply remove the two set-screws on the base and rotate the isolator 90 degrees, so that the two tapped holes on the cylinder are aligned with the mounting screws on the base.
Standard optical isolators have the following common specification values:
- 5mm Aperture
- Laser Damage Threshold (LTD) – CW Laser 500W/cm2 - Pulsed Laser 150MW/cm2
Conoptics isolators are supplied as follows:
- Faraday Rotator Isolator tuned to 45 degrees
- Including 2x Glan Polarisers
- Mounting Base
Conoptics Optical Isolator Alignment Procedure Datasheet
Conoptics Optical Isolator Tuning Ranges Datasheet
Write Your Own Review
Photo | Product | SKU | |
---|---|---|---|
Conoptics 350-390nm Optical Isolator 711C-1 | - | > | |
Conoptics 390-450nm Optical Isolator 711C-2 | - | > | |
Conoptics 425-500nm Optical Isolator 711C-3 | - | > | |
Conoptics 532-715nm Optical Isolator 712A | - | > | |
Conoptics 644-780nm Optical Isolator 712B | - | > | |
Conoptics 650-900nm Optical Isolator 713A | - | > | |
Conoptics 700-900nm Optical Isolator 712TGG | - | > | |
Conoptics 790-980nm Optical Isolator 713B | - | > | |
Conoptics 680-1080nm Optical Isolator 714 | - | > | |
Conoptics 965-1135nm Optical Isolator 715 | - | > | |
Conoptics 1020-1100nm Large Aperture Isolator 815 | - | > | |
Conoptics 1064nm Optical Isolator 716TGG | - | > | |
Conoptics Optical Isolator 716 Double | - | > |